Fishman SBT-C Manuel d'utilisateur télécharger pdf (Page 8)

Install the pickup

1. Widen the endpin hole to 15/32” (11.9mm) to accommodate the endpin jack.

For additional information, please refer to the Switchjack Installation Guide

located at ﬁ shman.com.

2. Solder the pickup “hot” wire to the Tip terminal, which is the shortest of

the three tabs. Solder the pickup shield to the Ground tab on the jack. Gently

tighten the strain relief.

Shield

Tip

(Short Terminal)

ratiuG

Switch

(Long Terminal)

Ring

(Medium Terminal)

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Fishman SBT-C Manuel d'utilisateur Page 8